230V 50/60 Hz 8W 1/8" F x 1/8" F Two-Way ODE Solenoid - Ruby Seat

230V Two-Way ODE Hot Water Solenoid - Ruby Seat, Ascaso Barista T

Complete hot water dispensing solenoid valve, normally closed, with a 3.0 mm orifice and a ruby valve seat for long service life against mineral wear. Listed for the Ascaso Barista T.

SPECIFICATIONS

• 230V, 50/60 Hz, 8W coil
• 1/8" F x 1/8" F ports
• Normally closed
• 3.0 mm orifice
• Ruby seat

COMPATIBILITY

• Fits: Ascaso Barista T
• Works with: hot water dispensing circuit

INSTALLATION

A moderate electrical/plumbing job, isolate power and water supply before disconnecting the coil and fittings; recommended for a qualified tech since it's a non-returnable electrical part once installed.

Espresso Parts guarantees a full refund or replacement of defective products. Most electrical items carry specified limited warranties, and Espresso Parts will repair or replace devices that fail due to a manufacturer defect. Important: special order items, equipment, electrical items (scales, heating elements, switches, flowmeters, vibratory pumps, thermostats, etc.), pump heads, solenoids, custom work, and books are not eligible for return, all sales are final on this merchandise. Learn more on our return policy page. Questions? Call 1-800-459-5594 or email info@espressoparts.com.

PRO TIPS

• A ruby seat resists scale pitting far better than a standard rubber or PTFE seat, so if this solenoid fails prematurely, check your water hardness and softener maintenance, scale buildup on the seat is the most common cause of a solenoid that won't fully close or drips after the shot.